is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

Tools and Supplies to Adjust an Above Ground Pool Sand Filter
1 Screwdriver set
2 Socket set
3 Adjustable wrench
4 Pliers
5 Teflon tape
6 Pipe cutter
7 PVC glue
8 Sand filter cleaner
9 Pressure gauge
10 Backwash hose.

How to Adjust an Above Ground Pool Sand Filter

Easy Steps to Adjust Your Above Ground Pool Sand Filter

Adjusting an above ground pool sand filter is an important part of maintaining a clean and healthy swimming pool. The sand filter helps to remove debris and contaminants from the water, ensuring that it is safe for swimmers. Here is a step-by-step guide on how to adjust an above ground pool sand filter:

Step 1: Turn off the Pump

Before adjusting the sand filter, it is important to turn off the pool pump. This will prevent any water from flowing through the system while you are making adjustments.

Step 2: Release Pressure

Next, you will need to release the pressure from the sand filter. To do this, locate the pressure release valve on the filter and open it up. This will allow any built-up pressure to escape.

Step 3: Remove the Filter Cap

Once the pressure has been released, you can remove the filter cap from the sand filter. This will give you access to the filter media inside.

Step 4: Inspect the Filter Media

With the filter cap removed, take a close look at the filter media. If it appears to be dirty or clogged, it may be time to clean or replace it. If the media is in good condition, you can move on to the next step.

Step 5: Adjust the Valve Settings

The valve settings on the sand filter control the flow of water through the system. To adjust these settings, turn the valve handle to the desired position. This will vary depending on the specific model of sand filter you have.

Step 6: Replace the Filter Cap

Once you have adjusted the valve settings, you can replace the filter cap on the sand filter. Make sure that it is securely in place and tightened down.

Step 7: Turn on the Pump

With the filter cap back in place, you can turn the pool pump back on. This will allow water to flow through the sand filter and begin filtering out any debris or contaminants in the pool.

Step 8: Monitor the Pressure

As the sand filter begins to filter the water, you will need to monitor the pressure gauge on the filter. If the pressure begins to rise too high, it may be time to clean or replace the filter media.

By following these simple steps, you can easily adjust an above ground pool sand filter and ensure that your swimming pool remains clean and healthy for all of your swimmers to enjoy.

ProSeries 24-Inch Top-Mount Sa...

Check Price
Radiant Sand Filter System for...

Check Price
ClearFlow Sand Filter System

Check Price
XtremepowerUS 19" Sand Filter ...

Check Price