BestSandFilter.com is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

Tools and Supplies to Install an Inground Pool Sand Filter
1 Screwdriver set
2 Adjustable wrench
3 Pipe wrench
4 Teflon tape
5 PVC cement
6 Hacksaw
7 Measuring tape
8 Rubber mallet
9 Pool filter sand
10 Pool filter cleaner

How to Install an Inground Pool Sand Filter

Step-by-Step Guide: Installing an Inground Pool Sand Filter

Installing an inground pool sand filter can be a bit of a daunting task, but with the right guidance and know-how, it can be accomplished with ease. Here are the steps to follow:

Step 1: Turn off the Power
Before beginning any work on your pool, it's important to turn off the power supply to the pool pump. This will ensure your safety while working on the filter.

Step 2: Remove the Old Filter
If you're replacing an old sand filter, you'll need to remove it from the plumbing system. This may require some cutting and gluing of PVC pipes, so make sure you have the necessary tools and materials on hand.

Step 3: Prepare the Area
Choose a location for your new sand filter that is level and easily accessible. Remove any grass or other vegetation from the area and create a stable base for the filter to sit on.

Step 4: Install the Base
Place the base of the sand filter onto the prepared area. Make sure it is level and stable.

Step 5: Connect the Plumbing
Connect the plumbing to the sand filter according to the manufacturer's instructions. This will typically involve connecting the inlet and outlet pipes, as well as the waste line.

Step 6: Add Sand to the Filter
Pour the required amount of sand into the filter. The amount of sand needed will depend on the size of your filter and the manufacturer's recommendations.

Step 7: Backwash the Filter
Once the sand is in place, it's important to backwash the filter to remove any debris or dust that may have accumulated during installation. Follow the manufacturer's instructions for this process.

Step 8: Turn on the Power
After the filter has been backwashed, turn the power supply back on and test the system to make sure everything is working properly.

Step 9: Monitor the Filter
Monitor the sand filter regularly to ensure it is working properly. Backwash the filter as needed and replace the sand every few years, as recommended by the manufacturer.

By following these steps, you can install an inground pool sand filter with confidence and enjoy crystal-clear water all summer long.

ProSeries 24-Inch Top-Mount Sa...


Check Price
Radiant Sand Filter System for...


Check Price
ClearFlow Sand Filter System


Check Price
XtremepowerUS 19" Sand Filter ...


Check Price