is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

How to Replace an Inground Pool Sand Filter

Step-by-Step Guide: Replacing Your Inground Pool Sand Filter

Replacing an inground pool sand filter can seem like a daunting task, but with the right steps, it can be done easily and efficiently. Here is a step-by-step guide on how to replace an inground pool sand filter:

Step 1: Turn off the Power Supply
The first step is to turn off the power supply to the pool pump. This is important to prevent any accidents or electrical shock while working on the sand filter.

Step 2: Drain the Pool Filter
Next, you need to drain the pool filter. To do this, you need to remove the drain plug and let the water drain out of the filter. Once the water has drained out, you can remove the sand from the filter.

Step 3: Remove the Old Sand
Now, it's time to remove the old sand from the filter. You can use a sand removal tool or a shop vac to remove the sand. Make sure to wear gloves and a dust mask to protect yourself from the dust and debris.

Step 4: Inspect the Filter Tank and Laterals
Once the old sand is removed, inspect the filter tank and laterals for any cracks or damage. If there is any damage, you need to replace the tank or laterals before proceeding.

Step 5: Add New Sand
Now, it's time to add new sand to the filter. Make sure to use the correct amount of sand as recommended by the manufacturer. Pour the sand into the filter tank slowly and evenly, making sure not to damage the laterals.

Step 6: Reassemble the Filter
After adding the new sand, reassemble the filter. Make sure to replace any gaskets or O-rings as needed. Tighten all the bolts and fittings to prevent any leaks.

Step 7: Prime the Pump
Before turning the power supply back on, you need to prime the pump. This involves filling the pump with water to prevent any damage to the motor. Follow the manufacturer's instructions for priming the pump.

Step 8: Turn on the Power Supply
Finally, turn on the power supply to the pool pump and check for any leaks or issues. Let the pump run for a few minutes to ensure that everything is working correctly.

In conclusion, replacing an inground pool sand filter may seem like a difficult task, but by following these steps, you can do it easily and efficiently. Remember to take all necessary safety precautions and follow the manufacturer's instructions for the best results.

ProSeries 24-Inch Top-Mount Sa...

Check Price
Radiant Sand Filter System for...

Check Price
ClearFlow Sand Filter System

Check Price
XtremepowerUS 19" Sand Filter ...

Check Price