Rather have a pro do it for you?
| Tools and Supplies to Clean an Above Ground Pool Sand Filter | ||||
|---|---|---|---|---|
| 1 | Pool filter cleaner solution | |||
| 2 | Pool filter cleaning wand | |||
| 3 | Pool filter cleaning brush | |||
| 4 | Screwdriver | |||
| 5 | Hose | |||
| 6 | Rubber gloves | |||
| 7 | Safety goggles | |||
| 8 | Teflon tape | |||
| 9 | Replacement sand or filter media (if needed) | |||
How to Clean an Above Ground Pool Sand Filter
Easy Steps to Clean Your Above Ground Pool Sand Filter
Cleaning an above ground pool sand filter is an essential maintenance task that needs to be done regularly to ensure your pool stays clean and healthy. Here are the steps to follow to clean your above ground pool sand filter:
Step 1: Turn off the Power
Before you start cleaning your sand filter, make sure to turn off the power supply to the pool pump. This is important to avoid any accidents or injuries while cleaning the filter.
Step 2: Backwash the Filter
The first step in cleaning your sand filter is to backwash it. To do this, turn your pool pump on and set it to backwash mode. Allow the pump to run for about 2-3 minutes or until the water in the sight glass is clear. This will help remove any debris or dirt that may have accumulated in the filter.
Step 3: Rinse the Filter
Once you have backwashed the filter, switch the pump to rinse mode and let it run for about a minute. This will help flush out any remaining debris or dirt from the filter.
Step 4: Remove the Sand Filter
Once you have rinsed the filter, turn off the pump and disconnect the hoses from the filter. Carefully remove the top of the filter and remove the sand from the tank.
Step 5: Clean the Filter Tank
After removing the sand, use a hose to clean the inside of the filter tank. Make sure to remove any debris or dirt that may have accumulated inside the tank.
Step 6: Inspect the Laterals
While the filter is open, inspect the laterals for any signs of damage or wear. Replace any damaged or worn laterals before adding the sand back into the filter.
Step 7: Add New Sand
After cleaning the filter tank, add new sand to the filter. Make sure to use the correct amount of sand as recommended by the manufacturer.
Step 8: Reassemble the Filter
Once you have added the sand, carefully reassemble the filter. Make sure to tighten all the screws and bolts properly to avoid any leaks.
Step 9: Turn the Power Back On
After reassembling the filter, turn the power back on and run the pump in normal mode. Check for any leaks or abnormalities and make sure the water is flowing properly.
In conclusion, cleaning your above ground pool sand filter is an important maintenance task that should be done regularly. By following these steps, you can ensure your pool stays clean and healthy all season long.
