How to Install an Above Ground Pool Sand Filter

Installing an above ground pool sand filter is a great way to keep your pool clean and clear. Follow these simple steps to install your new sand filter:

Step 1: Prepare the Area
Before you begin, make sure you have a level area to place the sand filter. This will ensure that the filter operates efficiently and effectively. Use a level to check the ground and make any necessary adjustments.

Step 2: Connect the Hoses
Connect the hoses to the inlet and outlet ports on the sand filter. The inlet hose should be connected to the pool pump and the outlet hose should be connected to the pool return.

Step 3: Add Sand
Remove the filter lid and pour sand into the filter. The amount of sand needed will vary depending on the size of your filter. Refer to the manufacturer’s instructions for the correct amount.

Step 4: Backwash the Filter
Before using the filter, it is important to backwash it. This will remove any debris or impurities that may be present in the sand. To backwash the filter, turn the valve to the backwash position and turn on the pump. Let the water run until it runs clear.

Step 5: Rinse the Filter
After backwashing, rinse the filter by turning the valve to the rinse position and turning on the pump. Let the water run for a few minutes until it runs clear.

Step 6: Set the Filter to Filter Mode
Once the filter has been backwashed and rinsed, set the valve to the filter position. Turn on the pump and the filter will begin to operate.

Step 7: Maintain the Filter
To keep your sand filter working properly, it is important to maintain it. Backwash the filter regularly to remove any debris or impurities that may be present in the sand. Check the sand level periodically and add more sand as needed.

Installing an above ground pool sand filter is a simple process that can be completed in just a few steps. By following these steps, you can ensure that your pool stays clean and clear all season long.